TL-3120 Motion Control User Manual
WWW.SZTROCEN.COM
55
The start speed is the initial speed of the laser head from rest to start
movement. If the cutting line is too thick at the initial position of cutting,
it indicates that the parameter value is too small. If the line jitters at the
initial position of cutting, this parameter value is set too large.
The speed factor controls the speed of turning during cutting. If the cutting
line is too thick when turning, the parameter is too small. If the cutting
line is too thin when turning and the graphics cannot be cut completely,
this case indicates that this parameter value is set too large, users should
set a smaller value.
The
【
Engrave ACC
】
is the change rate of speed during engraving. This
parameter is only valid during engraving. During the engraving process, if
the space distance of laser head is too large, then the
【
Engrave ACC
】
is
set too small and should be adjusted appropriately. If the space distance
of laser head is too small and the edge of graphics is not carved completely,
it indicates that the
【
Engrave ACC
】
is set too large and should be reduced
appropriately.
