WWW.AWC608.COM
2After cutting to the starting point of pressing
1)Debug graphics
Figure 1) Containing 100, 200, 300, 400, 500MM concentric
squares
Figure 2) Containing 20, 50, 100, 200, 300, 400, 500MM
concentric circles
2)Test running process
Figure 1, able to test the maximum speed, maximum
acceleration, cutting acceleration, cutting deceleration of each
axis separately
First set it to the
during operation, reduce the above parameter value. If it is
considered slow, increase the above parameter
Figure 2, mainly to test the minimum corner speed and
maximum corner speed
Run 20, 50, 100mm circle,
adjust the minimum corner speed
Run 200, 300, 400, 500mm circle, generally set at 600mm / s,
if stuck, adjust the maximum corner speed
Increase or decrease by 50
Definition of motion parameters
1
，
Space speed: It affect
during cutting.
2,Cut Jerk: affect the acceleration from the take
the maximum speed in the cutting process
3,Cut Decel Jerk
Motion controller user manual
2After cutting to the starting point of pressing
1)Debug graphics
Figure 1) Containing 100, 200, 300, 400, 500MM concentric
Figure 2) Containing 20, 50, 100, 200, 300, 400, 500MM
concentric circles
2)Test running process
Figure 1, able to test the maximum speed, maximum
acceleration, cutting acceleration, cutting deceleration of each
axis separately
First set it to the maximum speed of 1500mm / s. If it is stuck
during operation, reduce the above parameter value. If it is
considered slow, increase the above parameter
Figure 2, mainly to test the minimum corner speed and
maximum corner speed
Run 20, 50, 100mm circle, generally set at 80mm / s, if stuck,
adjust the minimum corner speed
Run 200, 300, 400, 500mm circle, generally set at 600mm / s,
if stuck, adjust the maximum corner speed
Increase or decrease by 50
Definition of motion parameters
speed: It affects the movement speed of the knife
: affect the acceleration from the take-
the maximum speed in the cutting process
Decel Jerk: It affects the amount of deceleration change
TC-6832
Motion controller user manual
46
Figure 1) Containing 100, 200, 300, 400, 500MM concentric
Figure 2) Containing 20, 50, 100, 200, 300, 400, 500MM
Figure 1, able to test the maximum speed, maximum
acceleration, cutting acceleration, cutting deceleration of each
maximum speed of 1500mm / s. If it is stuck
during operation, reduce the above parameter value. If it is
Figure 2, mainly to test the minimum corner speed and
generally set at 80mm / s, if stuck,
Run 200, 300, 400, 500mm circle, generally set at 600mm / s,
s the movement speed of the knife
-off speed to
: It affects the amount of deceleration change
