WWW.AWC608.COM
The software of this system is TroCut cad software, the supported
computer operating system is Windows (Windows XP, Vista, Win7,
Win8, Win10) operating system. Click the next step according to
the instructions on the interface. The next step is completed. There
are USB driver installation and operation software installation. Both
parts must be installed.
5. Commissioning process
1) Check if the power supply is installed correctly
2) Unplug all the signal terminals first, and only keep the 24V
power terminal
3) When the machine is powered on, if the screen is on, press the
stop button to stop, the panel installation is normal;
If the panel is not lit, check whether the power cord is connected
correctly, whether the switching power supply is bad, and whether it
meets the standard. Are the two ends of the CN1 cable securely
connected?
2: Check that the limit switches of each axis are installed an
up. Check whether the limit polarity of the axis and the level setting
of the input port are set according to the actual object.
The specific method is as follows:
1) After power off, plug back into the limited position terminal, after
power on again, directly press the stop button to stop;
2) Find the actual installation position of each limit switch
separately. When it is sensed by general manual, see whether the
limit switch corresponding to the test interface has changed or
Motion controller user manual
The software of this system is TroCut cad software, the supported
computer operating system is Windows (Windows XP, Vista, Win7,
) operating system. Click the next step according to
the instructions on the interface. The next step is completed. There
are USB driver installation and operation software installation. Both
parts must be installed.
. Commissioning process
he power supply is installed correctly
) Unplug all the signal terminals first, and only keep the 24V
) When the machine is powered on, if the screen is on, press the
stop button to stop, the panel installation is normal;
ot lit, check whether the power cord is connected
correctly, whether the switching power supply is bad, and whether it
meets the standard. Are the two ends of the CN1 cable securely
2: Check that the limit switches of each axis are installed an
up. Check whether the limit polarity of the axis and the level setting
of the input port are set according to the actual object.
The specific method is as follows:
1) After power off, plug back into the limited position terminal, after
, directly press the stop button to stop;
2) Find the actual installation position of each limit switch
separately. When it is sensed by general manual, see whether the
limit switch corresponding to the test interface has changed or
TC-6832
Motion controller user manual
24
The software of this system is TroCut cad software, the supported
computer operating system is Windows (Windows XP, Vista, Win7,
) operating system. Click the next step according to
the instructions on the interface. The next step is completed. There
are USB driver installation and operation software installation. Both
) Unplug all the signal terminals first, and only keep the 24V
) When the machine is powered on, if the screen is on, press the
ot lit, check whether the power cord is connected
correctly, whether the switching power supply is bad, and whether it
meets the standard. Are the two ends of the CN1 cable securely
2: Check that the limit switches of each axis are installed and set
up. Check whether the limit polarity of the axis and the level setting
1) After power off, plug back into the limited position terminal, after
2) Find the actual installation position of each limit switch
separately. When it is sensed by general manual, see whether the
limit switch corresponding to the test interface has changed or
