Triumph Tiger 1050 2008, Owner'S Handbook Manual

Page: 99 / 114

99
Maintenance and Adjustment
License Plate Light
Bulb Replacement
Remove the seat.
Disconnect the battery, negative (black) lead
first.
Remove the license plate.
Remove the two lower rear mudguard
fasteners. Gently pull the mudguard
rearwards to allow access to the license plate
light retaining nut.
Counter-hold the nut to prevent it from
turning and remove the license plate light
fastener screw. Collect the nut from the
mudguard.
1. Lower rear mudguard fasteners
2. License plate light fastener screw
Detach the license plate light from the rear
mudguard.
Carefully remove the bulb holder from the
back of the license plate light unit and
remove the bulb.
1. License plate light
2. Bulb holder
Installation is the reverse of the removal
procedure, noting the following:
Tighten the license plate lamp fastener to
26 lbf in (3 Nm) .
Tighten the lower rear mudguard fasteners to
53 lbf ft in (6 Nm) .
Reconnect the battery, positive (red) lead first.
Caution
Do not pull the rear mudguard more than
is necessary to access the license plate
light's inside fastener nut. Damage to the
rear mudguard will result from bending
the mudguard too far.
2
1
cedm
Caution
To avoid cable damage, do not pull the
bulb holder using the cables. Pull only on
the bulb holder.
2
1
cedn