This chapter covers matters specifically for 23 ppm copier.
Please refer this chapter, as well as other chapters in the instruction handbook, if you purchased a 23 ppm
copier.
●
Multi-Bypass
The multi-bypass described on page 8 and page 12 (
⁄
on page 8) is an optional equipment. When copying
onto transparencies or paper which cannot be set in the drawer, install the multi-bypass.
When using the hand-out mode (page 27) or the sheet copy (page 29), install the multi-bypass.
●
Program mode
Up to three combinations of copy modes and functions can be registered in the program mode (page 45
and page 46).
●
Copier management
The total number of copies made by each department can be managed for up to 250 departments in the
copy management mode (page 49).
●
Management code
Enter "2300" for the management code described on the second paragraph on page 50, the third paragraph
on page 57 and the third paragraph on page 62.
The management code can be changed. See "
8
MANAGEMENT CODE ENTRY" on page 64.
* The following item applies only in Australia and New Zeeland.
●
Image storage memory
The image storage memory is necessary to store the scanned images for editing and processing.
The 23 ppm copier is not equipped with the image storage memory. If the general purpose SIMM is
installed, functions described below can be used.
* Up to two 16 MB or 32 MB general purpose SIMMs (Maximum capacity is 64 MB) can be installed.
<The following are functions which can be used by installing the general purpose SIMM.>
• Duplex copy (page 20.)
• Page separation copy (page 21)
• Transp backing sheet mode (page 26)
• Hand-out mode (page 27)
• Sheet copy (page 29)
• Layout copy (page 35)
• Booklet copy (page 36)
• B cover copy mode (page 38)
• Form overlay (page 39)
• Print page numbers (page 42)
• Filing mode (page 43)
• Sort copy (page 44)
• Auto selection copy (page 65)
83
ABOUT 23 PPM COPIER
