CHAPTER 4 BASIC COPYING
4-8
3
1
2
5
4
6
6. Bypass Copy
When copying through the bypass slot, perform the following
procedure.
NOTE
• Only one sheet of paper can be set in the bypass table.
• When using curled paper, stretch the paper. If curling is not cleared,
place the paper with curled surface up.
• When using the bypass, the margin copy, border erase, APS, and
AMS functions cannot be used.
Set copy conditions such as the number of copies.
Press the Paper Source key to select "Bypass".
Adjust the bypass guides to the paper size indications on
both sides of the bypass table.
Set the paper face down all the way into the feed slot
aligning with the paper size indication.
When placing paper in the bypass table, set the paper
quickly all the way into the feed slot. When paper is fed,
release the paper. If the paper is not set properly, a paper
jam may be detected.
If paper is set obliquely, pull the paper out and then set it
again.
Set the original to start copying.
When the message “Add paper in bypass.” [“Add paper on
stack bypass.”] appears, set the next paper in the bypass
table. Copying will start. Set the required number of sheets of
paper one sheet at a time for copying.
