ConnectionError!
Triton Xerophyte Controller Unit preparation for commissioning
Commissioning is to ensure water is purged through the unit and any air is dispelled from the
system. During commissioning, alternating values are displayed on the Triton Xerophyte
Controller Unit screen. The purpose is the enable the installer to hold their hand under the
shower outlet to verify that the Triton Xerophyte is functioning correctly.
While the Triton Xerophyte Shower Mixer is in commissioning mode all other functionality is
locked out. Before commencing the commissioning process you MUST first ensure that the
isolating valves on the hot and cold inlets are fully open (Fig 11) and then turn on the water
supplies and check the entire installation for water leaks. Commissioning MUST be carried out
with suitable pipework/hose attached to the shower outlet and with the outlet directed to
waste. DO NOT run the Triton Xerophyte Shower Mixer without water.
When the above actions have been satisfactorily completed, turn on the electrical supply to
the Triton Xerophyte Mixer Unit.
WARNING: Failure to commission the Triton Xerophyte Mixer correctly could cause long term
damage to the shower.
Preparation for commissioning (Wireless Connectivity Only)
With batteries fitted into the Digital Controller, electricity supply to the Digital Processor unit
turned on, the wireless connectivity between the Digital Controller and Digital Mixer
Processor unit will be automatically undertaken. If the Digital Controller is connected to the
Digital Processor, the controller will display this symbol in the corner of the display.
If however either of the messages in Fig.26. are displayed on the Digital Controller
permanently then wireless connectivity should be undertaken manually.
Signal Symbol
Fig 26
Commissioning
28
To manually connect the Digital Controller with
Digital Mixer Processor unit, ensure that fully
charged batteries are fitted into the Digital
Controller.
1.
Isolate the electricity supply to the Digital
Mixer Processor Unit
2.
After at least 1 minute restore the electricity
to the Digital Mixer Processor Unit
3.
Within 2 minutes, with the Controller in sleep
mode, press the On/Off ( ) or remove and
replace the batteries in the Controller.
4.
If this does not restore wireless connectivity,
this process should be repeated.
5.
If for any reason the loss of connection
cannot be resolved, please contact IWSX
Customer Service in South Africa.
