Typical Suitable
Installations
13
Hot
Inlet Nut
Fig 2
To fit the flow regulator
1. Unscrew the hot inlet nut and remove the inlet pipe, O ring seal, inlet filter, and flow
regulator housing.
2. Fit the flow regulator into the flow regulator housing.
3. Refit the flow regulator housing, Inlet filter, O ring seal, and inlet pipe, secure with the hot
inlet nut. Note: the hot inlet nut only needs to be hand tightened.
With instantaneous water heater appliances, when the warm-up function is finished the user
may experience a brief temperature variation upon restart. This is because combination
boilers will turn off after the warm-up process has been completed, so when restarted, the
processing unit will
release a cold slug of water followed by a hot slug as the hot water
supply stabilises.
Geyser Rating
Regulator
24 to 30kW
7 L/min
White/
Green
30 to 36kW
9 L/min
White/
Orange
36kW+
None required
High-Pressure Instantaneous Hot Water System Installation Continued
On-demand gas heaters are not always able to supply an adequate flow rate of hot
water, particularly in winter. Triton recommends fitting a flow regulator (supplied
with the shower) into the hot inlet of the Triton Xerophyte Mixer Unit before
installation. Refer to the table for details (see Fig 2).
Flow Regulator
Housing
Inlet Filter
Inlet
Pipe
O Ring Seal
Flow Regulator
