DC7000 ANTIQUE
13
FITTING THE FIXED HEAD
Complete outlet pipework from the valve ending
in a 1/2” BSP female threaded fitting – not
supplied (fig 19).
Note the depth of thread on the fixed head unit
from the finished wall surface is 10mm (fig 20). It
is advisable that pipework installed in solid walls
be provided with sufficient free play inside a cavity
to enable any slack to be accommodated.
At this point it is advisable to fit a blanking plug in
the female fitting, turn on the valve and check for
leaks from the outlet fittings.
Make good the wall, tiling etc.
Screw in place the showerhead arm and mark the
position of the three fixing holes (fig 21).
Drill and plug the holes using the plugs supplied.
NOTE: If fitting to a hollow wall structure, use
suitable cavity wall fixtures.
Apply PTFE tape to the 1/2” BSP thread on the
shower head arm before fitting.
Secure the showerhead arm to the wall with the
three screws supplied (fig 22) .
Screw the ball swivel and locking ring onto the
end of the showerhead arm (fig 23) ensuring the
‘O’ ring is in place.
NOTE: The ball swivel must be screwed on tight in
order to provide a water tight connection. The use
of an appropriate tool may be used if necessary.
Screw on the fixed showerhead ensuring the
supplied tapered sealing washer is in place as
shown in (fig 24). The showerhead must be
screwed on tight in order to ensure a water tight
connection.
Ball swivel
Locking ring
'O' ring
Fig. 21
Fig.22
Fig.23
Fig.24
18mm
Wa
ll
surface
Fig. 19
Fig. 20
Summary of Contents for DC7000 Antique
Page 2: ...DC7000 ANTIQUE UKAS QUALITY MANAGEMENT 003...
Page 25: ...23 DC7000 ANTIQUE...
Page 26: ...DC7000 ANTIQUE 24...
Page 27: ......
