13
Aspirante pumped electric
otherwise water will flow as soon as the
electricity is switched on.
Attached to the Stop/Start switch inside the
cover is a two wire lead. The socket on the end
of this lead must be connected to the plug that
is situated at the bottom of the right-hand side
of the backplate unit
(fig.18)
.
Note:
The plug and socket can only fit one
way.
Replace the cover squarely to the backplate and
guide into position so that the controls locate
correctly into the spindles while at the same
time, making sure the wires are not trapped.
Should any difficulty arise, recheck the points
above.
Secure the cover temporarily in position with
two retaining screws. DO NOT OVERTIGHTEN.
Switch on the mains electric supply to the
shower at the isolating switch.
Press the Start/Stop button
(fig.19)
. The
power indicator will light and the pump starts
to operate.
It will take about thirty seconds for a smooth
flow of water to be obtained while air and any
debris is being flushed from the shower.
When a smooth flow of water is obtained,
rotate the temperature control from ‘1’ to ‘10’
several times
(fig.20)
to release any trapped air
within the unit.
Once flushing out has been completed, stop
the water flow by pressing the Start/Stop
button.
SWITCH OFF THE ELECTRICITY SUPPLY TO THE
SHOWER AT THE ISOLATING SWITCH.
Unscrew the cover retaining screws again and
lift the cover from the backplate. Remove the
locking screw from the power selector spindle
(fig.16)
and store for future use. Make sure the
selector spindle is left in the same position.
Replace the cover as described above and
permanently secure with the four retaining
screws. DO NOT OVERTIGHTEN.
Switch the mains electric supply back on to the
shower at the isolating switch. Once the riser
rail is fitted, the shower is ready for normal use.
Fig.18
Fig.19
Fig.20