COMMISSIONING
The first operation of the shower is intended to
flush out any remaining unit debris, and to
make sure the heater unit contains water before
the elements are switched on.
This operation must be carried out with the
flexible hose screwed to the outlet but without
the sprayhead attached. Make sure the outlet of
the flexible hose is directed to waste and the
Cold position selected.
To check that the temperature control is
correctly positioned on the stabilising valve,
temporarily place the cover in position so that
the splines engage then rotate the temperature
control fully anti-clockwise.
Remove the cover and position the temperature
control so that it points towards ‘1’
(fig.14)
.
Position the power selector to the Cold position
(fig.15)
.
DO NOT remove the locking screw fitted to the
power selector spindle
(fig.16)
– it can be
removed when the commissioning procedure
has been completed.
Make sure the water supply is still turned on to
the shower.
Open the bleed screw on the pump unit
(fig.17)
by rotating one revolution. When
water flows from the opening, this indicates
that any trapped air is vented and that the
pump unit is primed. The bleed valve must now
be closed by rotating in the opposite direction.
Offer the cover to the backplate unit. Make sure
the power selector is still at the Cold position
and the temperature control is at ‘1’.
Note:
Make sure the Start/Stop button is not
depressed in the cover which indicates ‘start’.
The button should be flush with the cover,
COMMISSIONING
PROCEDUR
E HAS
BEEN CARRIED OUT
REFER TO FIT
TING INSTRUCTIONS
Locking
screw
Bleed screw
Fig.14
Fig.15
Fig.16
Fig.17
12
Aspirante pumped electric
WARNING!
DO NOT switch on the electricity
supply until the following procedure
has been completed and the cover has
been fitted. Failure to do so could
cause the pump to run dry and
invalidate the guarantee.