7.
Remove both existing handle grips.
•
Some handle grips require that a phillips-head screw be
removed prior to removing the handle grip. If this is the
case, remember to also remove the cap inside the
handlebar so that it does not fall inside the handlebar
and rattle around as you ride.
•
Removal of the handle grips requires a lot of effort. You
may want to use a hot air blow gun to heat the material
before removing it.
Use extreme caution as this may
melt the handle grip material and/or cause a fire.
8.
Install the Throttle on the right side of the handlebar.
•
The throttle should slide all the way to the brake handle.
•
Once the throttle is against the brake handle, rotate the
throttle until the stop located on the inner face of the
throttle is resting against the brake handle. This will
align the throttle to the proper position.
•
Insert the plastic throttle sleeve over the handlebar so
that the sleeve slides inside the throttle.
The sleeve
flange will stop the sleeve against the throttle.
•
Install the half-sized handle grip over the remaining right
side of the handlebar.
•
Tighten the 3mm Allen socket bolt located on the
underside of the throttle making sure to keep the
throttle aligned as described above.
9.
Install the full-sized handle grip on the left side of the handlebar.