21. Install the front wheel motor assembly bundle – Part B
•
Connect the white plastic connecters from the
motor to the controller making sure to match the
wire colors along with the connecters.
•
Connect the four individual wires from the motor
to the same colored individual wires from the
controller. Slide the clear rubber sleeve (arrow)
that covers the metal connector portion of the
wire down the wire to expose the metal. Connect
the wires together and slide the clear rubber
sleeve back over the connection. This will insulate
the connection as well as keep the connection
together.
•
Connect the black connector from the motor to the
black connector from the battery. Note: You may
hear a pop sound when the connection is initially
made. This is normal.
•
Check the fuse in the small red box attached to the
power cable that was just connected in step 20.h.
•
Close the top flap of the bag assembly and close
the zippers so that the zipper tabs are located at
the front center of the bag assembly.
Pull the
Velcro tab down over the hole in the front center
of the bag.
