5-20
5-20
5-20
5-20
5-20
Installing and Removing Options
6
Press the ZIF handle back to close the ZIF socket.
7
Connect a fan connector cable from the microprocessor fan to the microprocessor
fan connector (J17) located beside the processor socket.
8
If necessary, you may need to change the jumper settings. Refer to "Changing the
Jumper Settings" and the label for jumper settings inside the system for more
information on jumper settings.
9
If you had removed any hard disk drive or option cards that block your access to
the microprocessor socket, replace them as described in "Installing an Option
Card" or "Replacing the Hard Disk Drive".
10
Replace the computer's cover as described in "Replacing the Cover".
1 1
Be sure to run the SETUP program so that your computer can automatically
update its configuration.
IDE Drives
Your system has two built-in PCI EIDE interfaces (primary and secondary). Each
interface supports up to two IDE drives (master and slave).
The BIOS in the motherboard supports bootup from an IDE CD-ROM drive. You can
boot the system from the IDE CD-ROM drive by setting the Boot Up Sequence option
of the Advanced Setup menu in SETUP to CDROM, A:,C:.
The hard disk drive controller on the motherboard supports Ultra DMA/33, a DMA
data transfer protocol for hard disk drives. This allows DMA commands to transfer
data at a maximum burst rate of 33MB/sec. Both the controller and the hard disk must
be capable of supporting Ultra DMA/33 in order to enable this feature.
