EZ-PILOT STEERING SYSTEM INSTALLATION INSTRUCTIONS
2 –
EZ-Pilot System Installation
34
Step 3
Re-install the original hex nut. Use a 27 mm
deep socket to tighten the nut.
Torque the nut to 33-40 ft-lbs
(44-54 Newton- meters).
Step 4
Rotate the motor's electrical connector to an
8:30 or 5:00 o’clock position.
Slide the anti-rotation pin fully upward. Align
the slots in the pin with the threaded holes in
the bottom of the motor. Use a 4 mm L-shaped
stubby hex wrench to install the supplied
5 mm x 12 mm hex socket screws.
Example tool:
, P/N AWMBS9
4 mm L-shaped stubby hex wrench
