© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPE-30102WS
18
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Creating IPv6 Static Routes
System > IPv6 > Route Settings
The switch supports IPv6 static IP routing which can be used to route traffic between
multiple IPv6 subnets.
1. Log into your switch management page (see “
Access your switch management page
on page 11).
2. Click on System, click IPv6, and click Route Settings.
3. Review the IPv6 Route Settings below. After you have entered all of the parameters
for the static route, click Add to add to the IPv6 Route table.
IPv6 Network Address / Prefix Length: Enter the IPv6 destination network
address and prefix.
(e.g. fc10::/64)
IPv6 Nexthop Address:
Enter the IPv6 gateway address used to reach the
destination IPv6 network.
(e.g. fc00::1)
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Summary of Contents for TPE-30102WS
Page 1: ...TRENDnet User s Guide Cover Page...
Page 112: ......