TRENDnet TPE-30102WS, User Manual, Page: 18 / 112

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPE-30102WS
14
Creating IPv4 Static Routes
System > IPv4 > Route Settings
The switch supports IPv4 static IP routing which can be used to route traffic between
multiple IP subnets.
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on System, click IPv4, and click Route Settings.
3. Review the IPv4 Route Settings below. After you have entered all of the parameters
for the static route, click Add to add to the IPv4 Route table.

IPv4 Network Address: Enter the IPv4 destination network address. ( e.g.
192.168.200.0)

Subnet Mask: Enter the IPv4 subnet mask of the destination network.
(e.g. 255.255.255.0)

Gateway IP Address: Enter the IPv4 gateway address used to reach the
destination network. (
e.g. 192.168.10.254)
4. Click Save Settings to Flash (menu).
5. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.