TRENDnet TPE-30102WS, User Manual, Page: 15 / 112

© Copyright 2018 TRENDnet. All Rights Reserved.
TRENDnet User’s Guide
TPE-30102WS
11
Set your IPv4 settings
System > IPv4 > IP Address
This section allows you to change your switch IPv4 address settings. Typically, the IP
address settings should be changed to match your existing network subnet in order to
access the switch management page on your network.
Default Switch IPv4 Address: 192.168.10.200
Default Switch IPv4 Subnet Mask: 255.255.255.0
1. Log into your switch management page (see “ Access your switch management page ”
on page 11).
2. Click on System, IP Address, and in the IPv4 address table for the VLAN1 interface,
click on Modify.
3. Review the settings. When you have completed making changes, click Apply to save
the settings.

Interface: Displays the VLAN interface the IP interface settings are assigned.

MAC Address: Displays the switch MAC address information.

IP Address: Enter the new switch IP address. (e.g. 192.168.200.200)

Subnet Mask: Enter the new switch subnet mask. (e.g. 255.255.255.0)

System IP Mode: Click the drop-down list and select Static to manually specify
your IP address settings or DHCP to allow your switch to obtain IP address
settings automatically from a DHCP server on your network.

DHCP Auto Configuration: If you need to automatically update the switch
configuration files via a remote server, the DHCP Auto Configuration feature is
available for this purpose via the DHCP server. Your IP address settings must
enable the DHCP client so that this feature can operate with your DHCP server.
4. Click Apply.
5. Click Save Settings to Flash (menu).
6. Click Save Settings to Flash (button), then click OK.
Note: This step saves all configuration changes to the NV-RAM to ensure that if the
switch is rebooted or power cycled, the configuration changes will still be applied.
Note: Default IPv4 gateway IP address must be specified under System > IPv4 > Route
Settings. For example: If your default gateway/router IP is 192.168.200.1, you would
need to add a new static route below to specify the default gateway to use to access
other IPv4 networks.