TRENDnet TEG-S2620is, User Manual, Page: 79 / 124

Advanced Setting
In Advanced setting, it has two sections – MAC Table Address Entry and Priority
Queue Service. After the configuration, click
Apply
button to complete the
configuration.
„
Enable MAC address Aging Out:
to enable the MAC address age out
function. When it is disabling, the following configure item will not function.
—
Age-out Time:
fill in the number of seconds that an inactive MAC
address remains in the switch's address table. The valid range is
300~765 seconds. Default is 300 seconds.
—
Max Bridge Transmit Delay Bound Control:
limit the packets queuing
time in switch. If enable, the packets queued exceed will be drop. This
valid value are 1sec, 2 sec, 4 sec and off.
—
Enable Low Queue Delay Bound:
limit the low priority packets queuing
time in switch. If the low priority packet stays in switch exceed Max Delay
Time, it will be sent. The valid range is 1~255 ms.
NOTE:
Make sure of “Max bridge transit delay bound control” is enabled
before enable Delay Bound, because Enable Delay Bound must be work
under “Max bridge transit delay bound control is enabled” situation.
—
Broadcast Storm Filter:
configure broadcast storm control. Enable it
and set the upper threshold for individual ports. The threshold is the
percentage of the port's total bandwidth used by broadcast traffic. When
broadcast traffic for a port rises above the threshold you set, broadcast
storm control becomes active. The valid threshold value are 5%, 10%,
15%, 20%, 25% and off.
73