T4
-8-
Adjusting the Depth of Cut
■
Place the machine on the workpiece.
■
Pre-set the 3-way turret stop (1) as required.
■
Undo the thumb knob (2) for securing the
depth stop (3).
■
Undo the plunge locking lever (4).
■
Lower the machine slowly until the cutter just
touches the workpiece and secure it with the
plunge locking lever (4).
■
Raise the depth stop in accordance with the
scale (5) for the depth of cut required and
clamp in place with the thumb knob (2).
The gap between the depth stop and the
turret stop screw determines the depth of
cut.
The rotating turret stop screws can be used for
pre-setting up to three depths of cut. Their
height can be adjusted using a screwdriver (6)
and an 8mm A/F spanner (7).
Off
On
By turning the turret stop, three depth
settings can be quickly made.
T4
Switching On & Off
■
A slide switch on the front of the motor body
is used to turn the router on and off. When
fitting the motor unit to the base, ensure that
the switch is facing forwards.
Make sure the machine is
switched off before connecting
it to the power supply!
Slide switch
Never make adjustments
when the router is running or
plugged in. Deep cuts should
always be routed in several passes.
3
5
4
2
3
6
1
7
.
MANU/T4 v2.0 30/8/07 1:08 pm Page 8