Trek Domane SL 2020, Service Manual

Page: 3 / 16

3 2
1
Install common components
8.
To adjust the seat height, loosen the seatpost
clamp bolt, adjust the height, and re-tighten
the bolt to the recommended torque value.
SEATPOST BOLT
NOTE
Use a long stem 5mm socket on
your torque wrench to tighten the seatpost bolt. This
will allow an improved fit on the bolt and will prevent
wrench marks on the bike finish.
B. Install the front derailleur
1.
Use the special carbon washer and bolt to
install the front derailleur at the base of the
front derailleur hanger. Tighten the bolt just
until the derailleur is held. Do not fully tighten
yet.
C. Install the rear derailleur
1.
Install the rear derailleur on the the rear
derailleur hanger. Tighten to OEM torque spec.
D. Install the chain keeper
1.
Install the chain keeper at the base of the
front derailleur hanger. Torque the bolt to 3Nm.
1
INSTALL COMMON COMPONENTS
A. Install and adjust the seatpost
TOOLS AND MATERIALS REQUIRED
• Saddle • Lower seal
• Seatpost • Long stem 5mm
hex
• Seatpost wedge and
bolts
• Torque wrench
1.
Remove any tape or rubber band from around
the seatpost wedge prior to installation.
2.
Install the lower seal into the bottom of the
seatpost.
NOTE
For full seatpost insertion, you may
need to remove the lower seal.
3.
Insert the seatpost into the seatmast. Be sure
to have the wedge placed in the seatpost prior
to insertion.
4.
Tighten the bolt just until the seatpost and
wedge are snug. Do not fully tighten yet.
SEATPOST BOLT
5.
Install the saddle. Make sure the clamp ear
correctly fits the saddle rail shape.
6.
To adjust the angle of the top of the saddle,
loosen the rear pinch bolt, adjust the angle,
then re-tighten the bolt.
7.
To adjust the fore/aft position of the saddle,
loosen the side rail clamp bolt, slide the
saddle, then re-tighten the bolt.