Trek Domane SL 2020, Service Manual

Page: 14 / 16

24 25
2020 Domane Service Manual
8
Install the T47 bottom bracket
D. Install the T47 bottom bracket
1.
Grease the threads on the bottom bracket.
2.
Grease the threads on the frame
3.
Start threading the bottom bracket into the
frame by hand:
•
Drive side: reverse threads
(left hand thread)
• Non-drive side: regular threads
(right hand threads)
4.
Use the installation tool specific to your
bottom bracket to torque the bracket to the
OEM spec. Do not exceed a maximum of
50Nm.
9
Install fenders
E. Install front fender
TOOLS REQUIRED
• 4mm hex head wrench, extended arm,
round head
• Loctite Blue 242
Trek recommends using Bontrager fenders.
Domane SL, SLR, and LT models
1.
Remove the set screw or plastic plug from
under the fork crown.
2.
Remove the two bolts from the fender
mounting tab and remove the tab.
3.
If the top mounting bolt has been used before
or the bolt has no adhesive, apply fresh Loctite
Blue 242 to coat the threads.
NOTE
The bolts included with your
Bontrager fender will have Loctite pre-applied.
The top mounting bolt should be a button-head
type and at least 0.5in (12.7mm) long.
4.
Use the bolt with Loctite to attach the fender to
the underside of the fork crown.
5.
Use the instructions that came with the fender
to complete the installation.
Domane HP models
1.
Remove the set screw or plastic plug from the
rear of the fork.
2.
If the top mounting bolt has been used before
or the bolt has no adhesive, apply fresh Loctite
Blue 242 to coat the threads.
NOTE
The bolts included with your
Bontrager fender will have Loctite pre-applied.
3.
Bend the fender tab as necessary to best fit
the angle of the fork.
4.
Use the bolt with Loctite to attach the fender
to the rear of the fork.
5.
Use the instructions that came with the fender
to complete the installation.