Trek Domane SL 2020, Service Manual

Page: 13 / 16

22 23
2020 Domane Service Manual
8 8
C. Assemble and install the
DT storage door
PARTS REQUIRED
:
1
2
5
8
3
6
4
7
1. Wave washer
2. Flat washer
3. Lever
4. Pin 5. Wings
6. Storage door
7. Screws (2)
8. Wing cover/Tool holder
1.
Preload the pin in the wing.
NOTE
Make sure the pin is not pressed into
the hole in the middle of the wings.
2.
Put the straight washer on the lever shaft.
3.
From the inside, put the wave spring over the
lever shaft.
4.
Put the wing over the lever shaft with the wing
ribbing visible.
5.
Line up the holes in the shaft and the wing
with the lever in the closed position and the
wing perpendicular to the water bottle line.
Assemble and install the DT storage door Assemble and install the DT storage door
6.
Press the pin through so it’s flush with the
wing.
7.
Set the tool holder tab in the channel on the
door.
8.
Install and torque the two screws to 1Nm.
9.
If equipped with a Bontrager multi-tool, push
the tool into the holder from the non-notched
side until it clicks into place.
10.
To release the tool, push on the tool at the
notch and pull up on the opposite side of the
holder. Push the tool out at an approximate
45-degree angle.
PRESS HERE
PULL HERE