www.traxontechnologies.com
©2020 TRAXON TECHNOLOGIES - AN OSRAM BUSINESS. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U. PATENTS, JAPAN PATENTS, OTHER PATENTS
PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
Installation Guide
IG0108EN V0.1 08/20
P. 18 of 29
Recording the UID (DMX/RDM Model Only)
Each ProPoint Vista luminaire is marked with a Unique Identifier (UID) on the product label. This UID is
used to address the luminaire for correct operation.
Example: 16DC:0834AA0B
AA0B represents the designation shown on the label.
Before completing installation, record each luminaire’s UID in a manner similar to the table included at
the end of this manual.
FIG.18: UID Location
Record the UID code
and physical location
from the label located
on the side of each
luminaire.
UID: *0834
2.3 Power Wiring
The ProPoint Vista luminaire is supplied with a 1.8 meter (6 foot) long power feed cable. This cable
may be field-cut to the required length by the installer.
WARNING
Risk of electrical shock. Make sure that the branch circuit is disconnected prior to
installation or inspection..
CAUTION
Make sure that the cable is protected from cuts and abrasions that may result in
damage to the outer jacket.
CAUTION
IP failure induced by stressed/damaged cable entry points during or after installation
will void the product warranty.
NOTICE
A voltage divider is recommended (and may be required by local electrical code)
when a single junction box is utilized for termination of the power supply and data
cables.
NOTICE
Cable bend radius must NOT be less than the Minimum Bending Radius (4 X Cable
Diameter) as specified by cable manufacturer and the Non-Bendable Length of 5cm
(2in) near the cable gland MUST be adhered to. In addition to the Minimum Bending
Radius, ensure that 5cm (2in) of cable at the connector junction is kept straight.
