www.traxontechnologies.com
©2022 TRAXON TECHNOLOGIES - AN OSRAM BUSINESS. ALL RIGHTS RESERVED. TRAXON™, TX CONNECT®, ARE TRADEMARKS OF TRAXON TECHNOLOGIES. U.S. PATENTS, E.U.
PATENTS, JAPAN PATENTS, OTHER PATENTS PENDING. SPECIFICATIONS ARE SUBJECT TO CHANGE WITHOUT NOTICE.
Installation Guide
02/22 V1.3
11 of 23
5. Connect Media Tubes
®
HO in the daisy-chained manner as detailed in the System
Diagram. There are two mounting options.
FIG.10: Mounting options for the tube
M6 x 23mm
Use Rear Studs For Alternative Mounting
Utiliser les goujons taraudés pour un montage
différent
Loosen mounting stud may lead to
water ingression into Media Tube.
Ne pas desserrer les goujons taraudés
sous perte d’étanchéité du Media Tube.
81mm / 3.2”
30mm / 1.2”
33mm / 1.3”
29mm / 1.14”
63mm / 2.5”
30mm / 1.2”
33mm / 1.3”
TAK!
IMPORTANT NOTE:
If no “Tak!” sound is heard or connector still not mated well, push both connectors inwards and manually rotate spring head of male connector
in the locking direction.
4. 3M Scotch
®
Rubber Splicing Tape 23* should be applied in
successive half-lapped, level-wound layers until desired buildup is
reached.
Connect
1. By pushing the cable connectors inwards, quick lock
connectors shall be mated and locked automatically.
2. Locking requirement of the quick lock connectors after mated:
• “Tak!” sound should be heard
• All 3 arrows should be in one straight line
• Connector cannot be pull out
TAK! and lock
Wrapping
3. Wrap female and male connector as well as end cap with 3M
Scotch Rubber Splicing Tape 23 (or other similar self-amalgamating
rubber tape) for secondary protection in the direction opposite to
the unlocking direction.
Water-proof
*For details, refer to the 3M Scotch
®
Rubber Splicing Tape 23 Data Sheet.
6. The first tube of the daisy-chain group has to be connected to the control system via
the Quick Lock Starter Cable or the RJ45 / Power Data to Quick Lock Injector Cable Kit
(TU.AC.0600400).
