22
Installation
(for qualified installers only)
Travis Industries
4060623
100-01170
Synchronizing the Remote and Wireless Wall Switch
NOTE
: The battery box, remote, and wall switch must have batteries to complete this process.
WARNING
: Shut the gas off to the fireplace prior to conducting this process.
Press the "Learn" button on the receiver module
until it beeps once (you may wish to use a pen or
other device to depress this button).
ON H/L
OFF
Continuous Pilot
MODE
SET
TEMP
°F
POWER
AUX
Learn
Continuous
Pilot
Off/On
Remote/Off
ADJ
Beep
Press the "OFF" button on the remote.
POWER
AUX
Learn
Continuous
Pilot
Off/On
Remote/Off
ADJ
Beep, Beep,
Beep, Beep,
Beep
The receiver will acknowledge the
signal by beeping 5 times.
Press the "Learn" button on the receiver module
until it beeps once (you may wish to use a pen or
other device to depress this button).
POWER
AUX
Learn
Continuous
Pilot
Off/On
Remote/Off
ADJ
Beep
ON
OFF
HI
LO
Press the "OFF" button on the wireless
wall switch.
POWER
AUX
Learn
Continuous
Pilot
Off/On
Remote/Off
ADJ
Beep, Beep,
Beep, Beep,
Beep
The receiver will acknowledge the
signal by beeping 5 times.
NOTE: Re-setting the Receiver Module
If the receiver module fails to synchronize with the remote or wall switch after two attempts, you
should re-set the receiver module. To do this, hold down the LEARN button on the reciever for
approximately 10 seconds until the receiver beeps 3 times. This indicates the receiver has been
re-set and can be synchronized using the instructions above.
