Transmitter Solutions HIVE-DX, Manual

Page: 3 / 8

3/8 6-1620026 rev.P4 22/02/2016
1
2
3
8
7
6
5
4
RELA
Y 1
RELA
Y 2
P2
P1
P3
PO
TENTIOMETER
DISPLA
Y
OUT1
OUT2
MEMORY
RADIO MODULE
12-24 Vac/Vdc
Power Supply
Door operator #2
Transmitter #2
PUSH
TO OPEN
Door operator #1
Transmitter #1
PUSH
TO OPEN
8
6
DISPLAY ERROR DESCRIPTION
F1ERR
It appears when there is an error during the erasing of all the transmitters already memorized in the relay 1.
F2ERR It appears when there is an error during the erasing of all the transmitters already memorized in the relay 2.
F ERR It appears when there is an error during the erasing of all the transmitters already memorized in both the relays.
FULL Memory full
E RAD It appears when there is an error during the learning of the transmitter.
EME Memory error
E DEL
It appears when there is an error during the erasing of a single transmitter already memorized.
LoWPW
Supply voltage too low.
INI
It appears when the memory is initialized.
MODE 1 - DUAL INDEPENDENT OUTPUTS
MODE 1 - Dual indipendent outputs
Program the transmitter 1 on the relay 1. The transmitter 1 activates the relay 1 for the
TON1 time.
Program the transmitter 2 on the relay 2. The transmitter 2 activates the relay 2 for the TON2 time.
PROGRAMMING - STEP BY STEP
1. Press briefly the P1 button. The display shows rad1 .
2. Press the button of the transmitter #1. The display shows done .
3. To quit, press briefly the P1 button.
4. Press briefly the P2 button. The display shows
rad2
.
5. Press the button of the transmitter #2. The display shows done .
6. To quit, press briefly the P2 button.
7. To enter the menu, press briefly the P3 button.
8. Set the item funCt to 1 .
9. Press briefly the P3 button.
10. Set the ton1 time to the desired value.
11. Press briefly the P3 button.
12. Set the ton2 time to the desired value.
13. Press briefly the P3 button.
14. Press briefly the P3 button.
15. Press briefly the P3 button.
ERROR REPORTING