Transition Networks
SM24DP4XA Install Guide
33769 Rev. A
Page
19
of
42
RST (Reset) button
By pressing the front panel RST (Reset) button for certain period of time, you can:
Reset the Switch
: To reboot and get the switch back to the previous configuration
settings saved.
Restore the Switch to Factory Defaults
: To restore the original factory default settings back to the switch.
Note
: Based on the table below, you can determine which task is being performed by reading the LED behaviors
while pressing the Reset button. Once the LED behaviors are correctly displayed, just release the button.
Table 5: RST (Reset) Button Descriptions
Task to perform
Press the RST button for
SYS LED
Behavior
Port Status LED
Behavior
Reset the Switch
2 ~ 7 seconds
Blinking
ALL LEDs OFF
Green
Restore to Defaults
7 ~ 12 seconds
Blinking
ALL LEDs stay ON
Green
Back Panel
The SM24DP4XA back panel provides the Ground Screw as shown below.
Side Panel
The SM24DP4XA left side panel has two fans. Make sure that the left side panel fan vents are not blocked after
installation.
