RLC-SVU01B-E4
26
Power-Up DynaView
On Power-Up, DynaView will
progress through 3 screens:
First Screen, Version # of the Boot,
full version # displayed.
This screen will display for 5 seconds
and move on to the second screen.
The contrast will also be adjustable
from this screen.
Second Screen, Application or No
Application.
This screen will display for 5 seconds
"A Valid Application Is Present" or "A
Valid
Application Is Not Present" and move
on to the third screen.
Third Screen, First screen of the
Application, the Chiller Tab.
Display Formats
Units
Temperature settings are in °F or °C,
depending on Display Units settings.
Settings can be entered in tenths or
whole degrees depending on a menu
setting at the TechView.
Dashes ("-----") appearing in a
temperature or pressure report,
indicates that the value is invalid or
not applicable.
Languages
English plus two alternate languages
may be installed with DynaView and
will reside in the main processor.
English will always be available.
Alternate languages must be
installed using TechView, Software
Download View.
TechView Interface
TechView is the PC (laptop) based
tool used for servicing Tracer CH.530.
Technicians that make any chiller
control modification or service any
diagnostic with Tracer CH.530 must
use a laptop running the software
application "TechView." TechView is a
Trane application developed to
minimize chiller downtime and aid
the technicians' understanding of
chiller operation and service
requirements.
NOTE: Important: Performing any
Tracer CH.530 service functions
should be done only by a properly
trained service technician. Please
contact your local Trane service
agency for assistance with any
service requirements.
TechView software is available via
Trane.com.
(http://www.trane.com/commercial/s
oftware/tracerch530/)
This download site provides a user
the TechView installation software
and CH.530 main processor software
that must be loaded onto your PC in
order to service a CH.530 main
processor. The TechView service tool
is used to load software into the
Tracer CH.530 main processor.
Minimum PC requirements to install
and operate TechView are:
• Pentium II or higher processor
• 128Mb RAM
• 1024 x 768 resolution of display
• CD-ROM
• 56K modem
• 9-pin RS-232 serial connection
• Operating system - Windows 2000
• Microsoft Office (MS Word, MS
Access, MS Excel)
• Parallel Port (25-pin) or USB Port
NOTE: TechView was designed for
the proceeding listed laptop
configuration. Any variation will
have unknown results. Therefore,
support for TechView is limited to
only those laptops that meet the
specific configuration listed here.
Only laptops with a Pentium II class
processor or better are supported;
Intel Celeron, AMD, or Cyrix
processors are not supported.
TechView is also used to perform any
CH.530 service or maintenance
function. Servicing a CH.530 main
processor includes:
• Updating main processor software
• Monitoring chiller operation
• Viewing and resetting chiller
diagnostics
• Low Level Intelligent Device (LLID)
replacement and binding
• Main processor replacement and
configuration modifications
• Setpoint modifications
• Service overrides
Controls Interface
