Assembly Instructions | ILM-E Servo Kits
21
Edition 10/2021 EN
Assembly
5.2.2 Bonding process
►
Clean and degrease the bonding surfaces on
the shaft (item 1 in Fig. 10) and rotor (item 1 in
Fig. 11) following the adhesive manufacturer’s
instructions.
►
Heat the rotor for 5 minutes at 60 °C in the
curing oven.
►
Following the manufacturer’s instructions,
apply a thin ring of adhesive (item 2 in Fig. 10)
to the bonding surface on the shaft (item 1 in
Fig. 10).
►
Following the manufacturer’s instructions, ap-
ply a thin ring of adhesive (item 2 in Fig. 11) to
the inner surface in the vicinity of the indexing
hole (item 3 in Fig. 11) on the rotor.
►
Align the rotor so that the indexing hole
(item 2 in Fig. 12) points towards the shaft (see
Fig. 12).
►
Push the rotor (item 1 in Fig. 12) onto the shaft
(item 3 in Fig. 12) and gently push it as far as it
will go.
NOTE
—
Do not press on the surfaces of the rotor
magnets as this could damage them.
—
Only press on the inner ring (item 1 in Fig. 13)
of the rotor when you push it onto the shaft.
The pressure points (item 2 in Fig. 13) should
be opposite one another.
►
Quickly remove any excess adhesive with a
dry cloth. Do not use solvents on the shaft or
magnets.
►
Carry out the curing process following the
adhesive manufacturer’s instructions.
Fig. 10: Adhesive ring on the shaft
1
2
Fig. 11: Adhesive ring on the rotor
1
2
3
Fig. 12: Pushing the rotor onto the shaft
1
2
3
Fig. 13: Pressure points on the inner ring
1
2
2
