Assembly Instructions | ILM-E Servo Kits
18
Edition 10/2021 EN
Assembly
5.1.2 Shrink-fitting
WARNING
Danger of burns on hot surfaces
Contact with the housing at the temperatures required for shrink-fitting can cause severe
burns.
►
Wear appropriate heat protection for your hands throughout the entire process.
—
Clean and degrease the housing and stator with isopropyl alcohol.
—
Apply a small amount of adhesive in the groove identified for the dowel pin in the
design guidelines and insert the dowel pin into the groove.
Fig. 6: Housing with dowel pin
◀
Dowel pin
—
Heat the stator housing to 100 °C for roughly 45 minutes.
NOTE
Select a temperature that is appropriate for your selected materials and ambient tempera-
tures.
