Toyota RS2000-3D, Instruction Manual

Page: 69 / 80

58
English
Trouble chart
❈ If trouble is still apparent in the machine, please contact where you purchased or our web.
site (Europe only).
Do not try to correct fault by yourself.
PROBLEM PROBABLE CAUSE CORRECTION
Breaking lower
thread Thread not wound evenly on the bobbin or not drawn up
correctly
Lower thread tension too tight
Lint is stuck in the bobbin case and inside the tension spring
P. 10, P. 14
P. 53 - P. 54
Remove lint and
fluff with a cleaning
brush
Skipping stitches Needle not fully inserted
Needle bent or blunt
Size or type of needle and thread not suitable for the material
Incorrect upper threading
Too much oil on the machine
P. 55
P. 56
P. 63
P. 14
P. 52
Irregular stitches Incorrect size of needle for the material
Upper thread tension is too loose
Incorrect lower thread tension
P. 63
P. 21
P. 53 - P. 54
The material not fed
correctly Pattern selection dial not set correctly
Feed teeth are down
Lint is stuck in the feed teeth
P. 65
P. 23
P. 57
Noisy machine Check the thread in shuttle, even the slightest amount of thread
inside the shuttle may cause noise or binding, use material like
tooth pick or cotton swab to clean P. 57
The material
puckers Upper or lower thread tension is too tight
Stitch too long for material
Thread too thick
Incorrect threading of upper or lower thread
P. 21, P. 53 - P. 54
P. 65
P. 63
P. 14, P. 11
Breaking needle Needle not correctly inserted
Needle bent
Needle clamp screw too loose
Upper thread tension too tight
Needle too fine for the material
Dials have been changed while the needle was down in the
material
P. 55
P. 56
P. 55
P. 21
P. 63
P. 65
Quilt60_EFNI.book Page 58 Thursday, March 30, 2006 3:44 PM