SCION
iM
2016 -
INTERIOR LIGHT KIT
Procedure
Page 21 of 24 pages
Issue: C 01/28/2016
DIO
(l)
Route the main harness (pink line) and wire
tie it in two locations (Fig. 8-10).
(m)
Connect the five pin connector of the main
harness (pink line) to the light module.
(n)
Trim all wire ties.
9.
Perform a Function Test.
(a)
Temporarily reconnect the negative battery
cable (Fig. 9-1).
CAUTION:
Do not touch the positive terminal
with hands or any tool.
(b)
If required, install a 30A fuse.
(c)
Open a door. The interior light kit should
light up. The switch LED should be ON.
(d)
With a door open, press the illumination
switch to cycle through all 7 of the colors
(Fig. 9-2). (Two blue color positions exist
when a door is open.)
(e)
With the key in the OFF position, close all
doors (including the trunk). The interior
light kit should turn off. The switch LED
should turn OFF too.
(f)
With all doors closed, turn the key to
ACC/ON. The switch LED should come
ON.
(g)
With all doors closed and with the key in the
ACC/ON position, press the switch to cycle
through all 7 of the colors and the off
position (Fig. 9-3).
(h)
Turn the key to the OFF position.
Fig. 9-1
Fig. 9-2
Blue Turquoise Green Yellow Red Purple White Blue
Fig. 9-3
Blue Turquoise Green Yellow Red Purple White Off
Fig. 8-10
Wire tie #18
Wire tie #19