Toyota LAND CRUISER LC200, Owner'S Manual

Page: 285 / 973

283
4-1. Before driving
4
D
riv
in
g
LC200_OM_OM60R59W_(WE)
■
Connecting and disconnecting a trailer (vehicles with 4-Wheel AHC)
Stop your vehicle and a trailer in line and perform the following:
● Connecting a trailer
Put the 4-Wheel AHC in the “LO” (low) mode.
Turn off the engine switch or the 4-Wheel AHC.
Connect a trailer.
Turn on the engine switch or the 4-Wheel AHC.
Select the “N” (normal) mode with the height select switch.
When a vehicle loaded with four occupants tows a trailer of about
1800 kg (4000 lb.) with more than about 180 kg (400 lb.) tongue load, the
normal mode may not be selected. However, there is no problem to con-
tinue normal driving. Drive with sufficient care because of large load.
●
Disconnecting a trailer
Put the 4-Wheel AHC in the “LO” (low) mode. (Make sure the vehicle
height is in the “LO” mode by pushing “

” on the height select switch.)
Turn off the engine switch or the 4-Wheel AHC.
Set the supporting leg of a trailer on the ground and raise the hitch by
100 mm (4 in.).
Turn on the engine switch or the 4-Wheel AHC.
Wait for about 20 seconds until the rear vehicle height is lowered by the
automatic leveling function.
Make sure the hitch is disconnected. If not, raise the hitch higher and
repeat steps 2 through 5.
Move the vehicle forward in the “LO” mode where the hitch does not
touch anything in the “N” (normal) mode.
Put the 4-Wheel AHC in the “N” mode.
1
2
3
4
5
1
2
3
4
5
6
7
8