Toyota 2GR-FE, Manual

Page: 823 / 1021

LU–6
2GR-FE LUBRICATION – OIL FILTER
LU
(d) Remove all dirt and foreign matter from the
installation surface and the inside of the cap on the
engine side.
(e) Apply a light coat of engine oil to the O-ring again
and install the oil filter cap.
NOTICE:
Make sure that the O-ring does not get caught
between the parts.
(f) Using SST, install the oil filter cap.
SST 09228-06501
Torque: 25 N*m (255 kgf*cm, 18 ft.*lbf)
NOTICE:
Make sure that there is no clearance between
the parts after tightening the oil filter cap.
(g) Apply a light coat of engine oil to a new O-ring and
install it to the oil filter cap.
NOTICE:
Remove all dirt and foreign matter from the
installation surface.
(h) Install the oil filter drain plug to the oil filter cap.
Torque: 13 N*m (127 kgf*cm, 10 ft.*lbf)
NOTICE:
Make sure that the O-ring does not get caught
between the parts.
4. ADD ENGINE OIL
(a) Clean and install the oil drain plug with a new gasket
Torque: 40 N*m (408 kgf*cm, 30 ft.*lbf)
(b) Add new oil.
Standard capacity
(c) Install the oil filler cap.
5. CHECK FOR ENGINE OIL LEAKS
(a) Start the engine. Check for engine oil leaks from the
connected parts of the oil filter cap and oil filter drain
plug.
SST
A128002E01
O-Ring
A128003E01
Item Standard Condition
Drain and refill with oil filter change 6.1 liters (6.4 US qts, 5.4 lmp. qts)
Drain and refill without oil filter
change
5.7 liters (6.0 US qts, 5.0 lmp. qts)
Dry fill 6.5 liters (6.9 US qts, 5.7 lmp. qts)