CAUTION
The gas supply and electrical power
shall be shut off before proceeding
with the conversion.
WARNING
This conversion kit shall be
installed by a qualifi ed
service agency in
accordance with the
manufacturer's instructions
and all applicable codes
and requirements of the
authority having
jurisdiction.
If the information in these
instructions is not followed
exactly, a fi re, explosion or
production of carbon
monoxide may result
causing property damage,
personal injury or loss of
life.
The qualifi ed service
agency is responsible for
the proper installation of
this kit.
The installation is not
proper and complete un-
til the operation of the
converted appliance is
checked as specifi ed in the
manufacturer's instructions
supplied with the kit.
If the unit is to be used on propane
convert as follows using the components
supplied with this fi replace:
MAIN BURNER
(332) ORIFICE (5021.31)
MINIMUM RATE SCREW (5005.016)
CONVERSION LABEL (5052.5206C)
LP GAS/
DU GAZ LP
12.5 in/wc /12.5 po/c.e.
(3.11 kPa)
13.9 in/wc / 13.9 po/c.e.
(3.45 kPa)
11.0 in/wc / 11.0 po/c.e.
(.95 kPa)
3/32” (2.38 mm)
Max.: 61,000 (17.9)
Min.: 46,200 (13.5)
260411 6-TC42C 5052.5206C
Date: ______________________
By / Par: ___________________
Kit # TC42.LPKTB/EB/EC for use with model:
Pour utilise avec du modèle:
This appliance was converted
to PROPANE GAS with this
kit on this date by the or-
ganization which accepts the
responsibility that this conver-
sion has been properly made.
/ Cet appariel etair converter
au gaz LP par l’emploi de la
trousse de conversion par une
organization qui accepte la
responsibilité pour une instal-
lation en bon état.
TC42
Series C
Propane Conversion
10
TC42.NG03C 020511-20
Note: Factory supplied components must be
used to ensure correct input.
After conversion confi rm proper manifold
pressure.
1. Ensure the burner, pilot and gas supply
are turned off, and the appliance has
cooled.
2. With a ½” wrench remove the natural gas
orifi ce (#25) and replace with propane
orifi ce (3/32”)(our part # 5021.31)
(Fig. #16)
3. Fully open the primary air shutter.
4.
Remove the pilot shield from the burner
tray by removing two screws (Fig. #17)
5. With a 7/16” wrench loosen the pilot head
on the pilot assembly by a half-turn
(Fig.
#18)
Fig. # 17
Fig. # 18
Fig. # 16
Summary of Contents for TC42.NG03C
Page 18: ...18 TC42 NG03C 020511 20 ...
Page 19: ...19 TC42 NG03C 020511 20 ...
