2) Attach the manifold and pilot supply tubes
to the bulk head fi tting and tighten. (Fig. # 2)
Ensure that all connections are gas tight.
3. Secure the electrical bulkhead plate and
gasket to the fi rebox. (2 screws) Attach the
ignition and sensor wires to the module.
Red end to the connector marked by the
red dot, white end to the connector marked
by the white dot(Fig. #3 & 4)
NOTE: If converting to propane refer to the
propane conversion section before
continuing. Pg. 10
BULKHEAD PLATE
2 SCREWS
3
TC42.NG03C 020511-20
Fig. # 3
Fig. # 2
Summary of Contents for TC42.NG03C
Page 18: ...18 TC42 NG03C 020511 20 ...
Page 19: ...19 TC42 NG03C 020511 20 ...
