* MANTEL CLEARANCE
A
12”
B
9”
C
6”
** MANTEL DEPTH
D
12”
E
6 3/4”
F
1 1/2”
MANTEL CLEARANCE
CHART
Minimum Clearances:
Side standoffs .......................................................0 in.
(0 mm)
Back standoffs ......................................................0 in.
(0 mm)
Top standoffs ........................................................0 in.
(0 mm)
Bottom of appliance ..............................................0 in.
(0 mm)
Adjacent side wall .................................................4 in.
(102 mm)
Ceiling to appliance ............................................24 in.
(610 mm)
*Mantel to appliance .................. ..........See Figure #2
**Maximum Mantel extension .. ..........See Figure #2
Mantel support ......................................................4 in.
(102 mm)
Vertical vent pipe ..........................................1 3/4" in.
(45 mm)
Horizontal Vent pipe (Top, sides and bottom) 1 3/4" in.
(45 mm)
Fig. #1
Fig. #2
Fig. #3
MAY USE COMBUSTIBLE
FACING MATERIAL IN THIS AREA
NON-COMBUSTIBLE
FINISH MATERIAL
SEE FIG #7
NON-COMBUSTIBLE ZONE.
DO NOT INSTALL ANY COMBUSTIBLE MATERIAL,
ELECTRICAL WIRING OR GAS PLUMBING IN THIS
AREA.
COMBUSTIBLE FRAMING AND
FINISH WALL ABOVE STANDOFFS
STANDOFFS
STEEL FRAMING
FIREPLACE FRONT
TOP OF LINTEL BAR
A
B
C
D
E
F
MANTEL
ADJACENT WALL
OR MANTEL SUPPORT
CEILING
UNIT MAY BE RECESSED UP TO 6” WITH
NON-CUMBUSTIBLE MASONRY TYPE MATERIAL
*
45 1/4
21 3/4
31 1/2
10 3/4
11
34 1/16
31 1/2
28 3/16
32
40 1/4
LINTEL WIDTH
LINTEL HEIGHT
5
TC30_CE3 250313-
Fireplace Dimensions
Minimum Clearances to Combustible Material
STEEL STUD
FRAMING KIT IS
WIDER THAN UNIT
Summary of Contents for TC30.CE3
Page 42: ...42 TC30_CE3 250313 44 Notes ...
