A Firebox Panel Set must be installed for safe operation. Do not use the fireplace without
panels. Unpack and inspect all panels. The panels need to be installed before the logs are
in place.
Caution:
The Firebox Panels are very fragile, and should be handled with care.
1. Remove the Side Panel Retainer located on the underside of the firebox heat shield.
The retainer slips between the lip of the firebox and the heat shield and is retained in
place by two screws (Fig. 44b & Fig. 44c).
2. Install the Lower Rear Panel.
PARK AVE. BEIGE HERRINGBONE ........................................................... TCPN.30PAC
MOUNT VERNON RED HERRINGBONE ....................................................TCPN.30VRC
MANHATTAN BEIGE STACKED BRICK .................................................... TCPN.30MNC
BLACK PORCELAIN .....................................................................................T
CPN.770.C
COFFE BEAN BROWN PORCELAIN ......................................................T
CPN.770CB.C
(See Porcelain panel instruction manual for specific instructions for these panels)
Before
proceeding see burner instructions.
TC30 PANELS
SIDE PANEL RETAINER
HEAT SHIELD
FIREBOX LIP
Fig. #44b
SCREWS
Fig. #44c
REAR LOWER PANEL
ADJUSTABLE “V” BRACKET
The lower rear panel is held tight against the
side panels by two "V" brackets located on
the firebox rear wall. Although the brackets
are adjusted at the factory for the best fit,
some adjustment may be necessary. Adjust
the angle of the bracket by hand to ensure
a snug fit.
27
TC30_CE3 250313-
Firebox Panels Installation
Fig. #44
Summary of Contents for TC30.CE3
Page 42: ...42 TC30_CE3 250313 44 Notes ...
