7
❏
14. Position the control horn on the aileron so that the
pushrod is aligned with the aileron servo arm and the holes
in the control horn are aligned with the aileron hinge line.
Mark the two control horn mounting holes.
❏
15. Drill 1/16" [1.5mm] holes at the marks.
Do not
drill
completely through the wing.
❏
16. Mount the control horn to the aileron with two 2x10mm
sheet metal screws.
❏
17. Remove the screws and control horn and harden the
screw holes with thin CA. Once the CA has cured, reinstall
the control horn.
❏
18. Switch on the transmitter and receiver. Make sure the
aileron servo arm and aileron are centered. Mark the pushrod
where it crosses the outer hole of the aileron servo arm.
❏
19. Make a 90 degree bend at the mark. Trim off the end
of the pushrod ¼" [6.5mm] from the bend.
❏
20. Insert the pushrod and secure it with a nylon Faslink.
Slide the silicone clevis retainer over the clevis.
