6
❏
7. Remove the servo mounting screws and servo and
apply a drop of thin CA in each hole to harden the threads
in the wood blocks.
❏
8. After the CA has cured, reinstall the aileron servo
and screws.
❏
9. Tie the string from inside the wing to the end of the
aileron servo wire. Wrapping a piece of masking tape around
the end of the servo wire and the string will help when pulling
the servo wire through the wing.
❏
10. Pull the servo wire through the wing and route the wire
out of the hole in the top of the wing.
❏
11. Mount the aileron servo hatch to the wing with four
2x10 mm sheet metal screws and 2 mm fl at washers. After
installing the screws, remove the screws and hatch. Then,
harden the screw holes with thin CA. After the CA cures,
reinstall the screws and hatch.
❏
12. Thread a nylon clevis 20 turns onto the 2-56 x 4-3/8"
[110 mm] metal pushrod. Slide a silicone clevis retainer over
the clevis.
❏
13. Attach the clevis in the middle hole of the nylon
control horn.
