17
❏
8. Slide the cowl over the motor. Insert the plywood tab at
the lower back of the cowl into the slot at the bottom of the
fuselage. Position the tab at the upper back of the cowl over
the slot in the top of the motor box and push the cowl down.
IMPORTANT: Do Not
install the propeller and spinner until
after the control throws have been checked.
Finish Assembly
❏
1. Center the headrest behind the cockpit. Mark the outline
of the head rest on the turtledeck.
❏
2. Use a T-pin to pierce holes through the covering just
inside the outline of the headrest. This will strengthen the
glue bond between the headrest and turtledeck.
❏
3. Wipe off the outline on the turtledeck. Lightly sand the
bottom of the fl ange on the head rest and clean it off with
denatured alcohol. Glue the headrest on the turtledeck with
Formula 560 canopy glue or thin CA.
❏
4. Install the intrument panel decal. Use canopy glue to glue
the wind screen in front of the cockpit. We do not recommend
CA. It may fog the wind screen.
