TLP Pro 520M and TLC Pro 521M Rear Panel Features
The rear panels of the TLP Pro 520M and TLC Pro 521M are identical except for the RS-232,
Relay, and IR/S ports on the TLC Pro 521M.
A
B
F
G
H
RS-232
Relay
IR/S
Tx Rx G
1 2 C
S G
C
E
D
TLP Pro 520M
TLC Pro 521M
Figure 3.
TLP Pro 520M and TLC Pro 521M Rear Panel Features
A
Power connector
E
IR/S Connector
(TLC Pro 521M only)
(page 11)
B
Digital input monitoring port
(page 10)
F
Reset LED
(page 11)
C
RS-232 Connector
(TLC Pro 521M only)
(page 10)
G
Reset button
(page 11)
D
Relay Connector
(TLC Pro 521M only)
(page 10)
H
Network and Power over Ethernet
(PoE) connector
(page 11)
ATTENTION:
•
Do not power on the touchpanels or control processors until you have read the
Attention notice on
page 9
(12 VDC power supply) or on
page 12
(PoE injector).
•
Ne branchez pas les écrans tactiles ou les contrôleurs avant d’avoir lu les mises en
garde
page 9
(source d’alimentation 12 VCC) ou
page 12
(injecteur PoE).
A
Power connector
— Connect this 2-pole, 3.5 mm captive screw receptacle to a
12 VDC, 1.0 A power supply (not provided). Extron recommends the
PS 1210C
power
supply.
Ensure the connections have the correct polarity as shown in
figure 4
(on the following
page).
WARNING:
The two power cord wires must be kept separate while the power
supply is plugged in. Remove power before wiring.
AVERTISSEMENT :
Les deux cordons d’alimentation doivent être tenus à l’écart
l’un de l’autre quand l’alimentation est branchée. Couper l’alimentation avant de faire
l’installation électrique.
NOTE:
The TLP Pro 520M and TLC Pro 521M are shipped without a power supply.
Either the 12 VDC power supply or the PoE injector must be purchased separately.
TLP Pro 520M and TLC Pro 521M • Panel Features
8
Summary of Contents for TLC Pro 521M
Page 6: ......
