58
59
■
Replacing the batteries
1
Remove the cover on the left
side of the main unit, and flip the
power switch to "OFF".
(Page 15)
2
Remove the remote control
from the hanger.
(Page 14)
3
Open the battery cover and replace
the two AA batteries.
(Page 14)
•The low battery warning mark goes off.
4
Mount the remote control in the
hanger.
5
Flip the power switch to ON.
(Page 15)
•The "Power" LED lights up.
<Power>
6
Reinstall the cover.
(Page 31)
If the water does not flow due to a water service interruption
When the ambient temperature is likely to drop to 32 °F (0 °C) or lower, take measures to
prevent freezing.
Attention!
• When the ambient temperature is likely to drop to 32 °F (0 °C) or lower, do not use the energy saver feature.
(May damage the product.)
• Warm the bathroom or take measures against freezing so that the ambient temperature does not drop below
32 °F (0 °C).
•Before starting to work, set "Auto flushing" (Page 40) and "Auto open/close" (Page 42) to "OFF"
How to freeze damage prevention
5
When water draining is
completed, reinstall the water
filter drain valve.
•Insert the water filter drain valve and use a
flat-head screwdriver to tighten it securely.
6
Flip the power switch to ON.
(Page 15)
•The "Power" LED lights up.
7
Reinstall the cover.
(Page 31)
8
Set the toilet seat temperature
to "High".
(Page 24)
•To maintain the temperature, close the toilet
seat and toilet lid after finishing work.
To use the product again
•The water needs to be resupplied. (Page 61)
What to Do?
1
Use a bucket to flush water.
2
If the water level is low after
flushing, add more water.
•Prevents odors.
Attention!
•Before starting to work, set "Auto flushing" to "OFF". (Page 40)
•When water supply is restored, be sure to perform a full flush. (To prevent waste from remaining in the drain pipe.)
Newspaper, dustcloth, etc.
Large bucket
Pour strongly,
aiming at the
center of the
bowl unit.
Freeze Damage Prevention
Attention!
•"ON" and "OFF" settings of the functions such as the energy saver function may be canceled when the batteries are replaced.
Set them again.
If the low battery warning mark "
"
on the display screen on the back of the
remote control lights up, please replace the
batteries.
If you cannot operate with the remote control
MENU
1.MANUAL
CLEANING
1/5
Low battery
warning mark
If the water does not flow due to a water service interruption
If you cannot operate with the remote control
1
Close the shutoff valve.
(Page 63)
•The water supply stops.
CAUTION
Do not remove the water filter
drain valve while the shutoff
valve is open.
(Otherwise, water may leak out.)
2
Press
"Wand CLEAN" button.
(Release the pressure from the water supply
pipe.)
3
Remove the cover on the left side
of the main unit, and flip the power
switch to "OFF".
(Page 15)
4
Remove the water filter drain
valve.
•Loosen the water filter drain valve with a flat-
head screwdriver and then pull it.
Water filter drain valve
Flat-head screwdriver
Reference
