Toshiba TOSVERT VF-S15 series, Instruction Manual

Page: 264 / 394

E6582175
G-5
7

List of logic input terminal function settings
Parameter
programmed value
Function
Parameter
programmed value
Function
Positive
logic
Negative
logic
Positive
logic
Negative
logic
   
No function
   
Integrating wattmeter (kWh) display
clear
    Forward run command     Trace back trigger signal
   
Reverse run command
    Light-load high-speed operation
prohibitive signal
    Standby     Holding of RY-RC terminal output
    Reset command     Holding of OUT-NO terminal output
    Preset-speed command 1     Frequency UP *2
   
Preset-speed command 2
   
Frequency DOWN *2
   
Preset-speed command 3
   
Clear frequency UP/DOWN *2
   
Preset-speed command 4
   
Coast stop command
   
Jog run mode
   
Forward/reverse selection
   
Emergency stop by external signal
   
Run/Stop command
    DC braking command
    Frequency reference command forced
switching
   
2nd acceleration/deceleration
   
Frequency setting mode terminal block
   
3rd acceleration/deceleration
   
Command mode terminal block
    2nd V/F control mode switching     Parameter editing permission
    2nd stall prevention level     Fast stop command 1
    PID control prohibition     Fast stop command 2
    External thermal error input     Traverse permission signal
    Forced local from communication     Low voltage operation
   
Operation hold (hold of 3-wire operation)
   
Forward deceleration
   
PID integral/differential clear
   
Forward stop
   
PID characteristics switching
   
Reverse deceleration
   
Forced run operation
   
Reverse stop
    Fire speed operation  to  Factory specific coefficient *1
    Acceleration/deceleration suspend signal   No.2 motor switching
    Power failure synchronized signal     Parameter editing prohibition
    Factory specific coefficient *1     Parameter reading prohibition
    Factory specific coefficient *1  
*1: Factory specific coefficients are manufacturer setting menus. Do not change the value of these parameters.
*2: Active when
 (frequency setting mode selection) =  (UP/DOWN from external logic input) is set.
The frequency setup range is from

to

(maximum frequency). The acceleration/deceleration time
relative to the set frequency is  /  while the acceleration/deceleration speed is not switched.
● Refer to section 11.6 for details about the input terminal function.