Toshiba SD-1300A, Service Manual

Page: 43 / 93

2-3
Fig. 2-1-5
1-1-4. Front Panel and Tray
1. Remove the flexible cable (1).
2. Release four claws and remove the front panel (3).
3. Pull out the tray (2) to this side.
Fig. 2-1-6
Note:
• Insert the tray (2) with the front side of the pickup
mechanism assembly descended. (The slider positions
to the left side.)
• The gears are required to match their phases each
other. After setting the gear (3) as shown in the figure
“A”, insert the tray (2). When inserting a tray (2), push
the rack gear side shown by the arrow.
• Confirm that the mark of the gear matches with the
triangle mark on the reverse side of the tray in the tray
close status. (The gear is rotated with the slider locks.)
(Refer to Fig. B.)
Fig. 2-1-7
1-1-5. Rear Panel
1. Remove six screws (1) and remove the rear panel (2).
Fig. 2-1-8
Claw
Tray (2)
Claws
Front panel (3) Claw
Flexible cable (1)
Tray (3)
Tray
panel (4)
Tray (3)
Claws
Tray
panel (4)
A
B
Screws (1)
Rear panel (2)
Screws (1)
Fig. A
Gear (4) Triangle mark
Position of the line
Pickup mechanism
assembly
Gear (4)
Tray rack gear
Tray (2)
Slider
Triangle mark Marking
Gear
Fig. B