10-3. Indoor Unit
10-3-1. Installation Place
• A place which provides the spaces around the
indoor unit as shown in the diagram.
• A place where there are no obstacle near the air
inlet and outlet.
• A place which allows easy installation of the piping
to the outdoor unit.
• A place which allows the front panel to be opened.
• The indoor unit shall be installed as top of the indoor
unit comes to at least 2 m height. Also, it must be
avoided to put anything on the top of the indoor
unit.
CAUTION
• Direct sunlight on the indoor unit's wireless
receiver should be avoided.
• The microprocessor in the indoor unit should
not be too close to RF noise sources.
(For details, see the owner's manual.)
<Remote control>
10-3-2. Cutting a Hole and Mounting
Installation Plate
<Cutting a hole>
When install the refrigerant pipes from the rear.
1. After determining the pipe hole position on the
installation plate (
ð
) drill the pipe hole
(
∅
65 mm) at a slight downward slant to the
outdoor side.
NOTE :
• When drilling a wall that contains a metal lath,
wire lath or metal plate, be sure to use a pipe hole
brim ring sold separately.
<Mounting the installation plate>
Fig. 10-3-2
m from the right side edge is
e
center of pipe hole
35
120
180
240
23 mm
∅
65 mm
The center of the pipe hole is above
the arrow
.
Pipe hole
Fig. 10-3-1 Fig. 10-3-3
FILE NO. SVM-12056
5
4 °
45
°
5
7
°
(Top view)
Reception
range
Remote
control
Remote
control
(Side view)
Indoor unit
Indoor unit
Recep
tion range
To unit out line
240mm
To unit out line
35mm
To unit out line
240mm
Of
fset 23mm from the r
ight side edge is
the center of pipe hole
To unit out line
120mm
0
23
35
120
180
240
Of
fset 85mm from the left side edge is
the center of pipe hole
170
170
5
0
4
0
85
132
23
∅
65
mm
Hook
Hook
Hook
Pipe hole
Pipe hole (
∅
65 mm)
Weight
Indoor unit
Thread
2
m
o
r
m
o
re
f
ro
m
f
lo
o
r
Anchor bolt holes
1
Installation plate
7
Mounting
screw
•
A place where there are no obstacles such as a
curtain that may block the signal from the remote
control.
•
Do not install the remote control in a place
exposed to direct sunlight or close to a heating
source such as a stove.
•
Keep the remote control at least 1 m apart from
the nearest TV set or stereo equipment. (This is
necessary to prevent image disturbances or noise
interference.)
•
The location of the remote control should be
determined as shown below.
–
53
–
Summary of Contents for RAS-18N3AV2-E
Page 108: ...TOSHIBA CARRIER THAILAND CO LTD ...
