63
Getting Started
Adding memory (optional)
5.375 x 8.375 ver 2.3
You can now continue setting up the computer. When the
operating system has loaded, you can verify that the
computer has recognized the additional memory module.
If you are adding an extra memory module after setting up the
computer, verify that the computer has recognized it correctly
as described in
“Checking total memory” on page 65
Removing a memory module
If you need to remove a memory module:
1
Complete steps
“Installing a memory module” on
to shut down the computer and open the memory
module slot cover.
Do not try to remove a memory module with the computer
turned on. You can damage the computer and the memory
module.
Do not remove the memory module while the computer is in
Standby or Hibernation mode. The computer could hang up
the next time you turn it on and data in memory will be lost. In
either of the above cases, the Standby configuration will not be
saved.
The following message appears when you turn on the power:
Warning: Resume Failure
Press Any Key to Continue
If the computer hangs up when you turn it on, perform the
following: Press the power button and hold it down for at least
ten seconds, then turn the power on again.
