Toshiba Portege 3500, User Manual

Page: 135 / 242

Optional Devices
User’s Manual 8-9
Portégé 3500
Version
1
Last Saved on 17.10.2002 17:29
If you install a memory module that is not compatible with the computer,
beep will sound when you turn on the power. If the module is installed in
slot A, there will be a long beep (1 second) followed by two short beeps
(0.5 second each). If the memory module is in slot B, there will be a long
beep followed by four short beeps. If the both memory modules in slot A
and slot B are incompatible, there will be a long beep followed by two
short beeps and after a pause (1 second) a long beep followed by four
short beeps. In this case, shut down the power and remove the
incompatible module(s).
Be sure to install memory module to Slot A. The computer does not boot
when Slot A is vacant.does not boot when Slot A is vacant.
Use a 1-bit, Phillips screwdriver to remove and fasten screws. Use of an
incorrect screwdriver can damage the screw heads.
6IQSZMRKERHMRWXEPPMRKQIQSV]QSHYPIMR7PSX%
Follow the steps below to remove and install a memory module in Slot A.
1. Turn the computer’s power off. Make sure the
Power
indicator is off.
2. Remove AC adaptor and all cables connected to the computer.
3. Turn the computer upside down with the front side of the computer
facing to you and remove the battery pack. Refer to Removing the
Battery Pack in chapter 6; Power and Power-up Modes for the detail.
4. Turn the computer to the normal position and open the display panel.
Tilt the display panel slightly beyond the upright position before
removing the keyboard display.
5. Put your fingers on the both ends of the keyboard brace and remove it
carefully to the direction indicated with arrows.
Removing the keyboard brace
K
EYBOARD
BRACE