Toshiba IPedge, Installation Manual

Page: 138 / 196

AUDIOCODES MEDIANT1000 T1 Trunk Protocol and Configuration
12-18 Installation Manual June, 2011
AUDIOCODES
MEDIANT1000 T1 This section is for setting up an AudioCodes Mediant 1000 as a T1
gateway.
Refer to “BASIC CONFIGURATION” on page Chapter 12 – 13 for the
administrative and software version setup.
MEDIANT 1000
CONFIGURATION 1. Log into the AudioCodes gateway.
2. Click on Configuration .
3. Select the FULL radio button.
4. Select PSTN Settings > Trunk Settings .
In the Protocol Type field select T1 CAS .
Click on the Apply Trunk Setting button (A screen alert may pop up
to inform you must reboot.)
5. Click on the BURN icon at the top of the screen. A Green light may
appear on the screen or T1 port after reset to indicate Layer 1 and
Layer 2 are up.
6. Select Device Actions > Reset (at top of screen)
7. Click on the Reset button next to “Reset Board.”
8. Select PROTOCOL CONFIGURATION > TRUNK GROUP > TRUNK
GROUP . Set the following:
Trunk Group Index =1
Module = Module 1 PRI
From Trunk =1
To Trunk =1
Channel 1-8 (or how big your card is)
Trunk Group ID = 1
9. Select PROTOCOL CONFIGURATION > TRUNK GROUP > TRUNK
GROUP SETTINGS . Set the following:
Trunk Group ID = 1
Channel Select Mode = Ascending
10. Select PROTOCOL CONFIGURATION > PROTOCOL DEFINITION
> SIP GENERAL PARAMETERS
Fax signaling method = G711 Transport
11. Select PROTOCOL CONFIGURATION > PROTOCOL DEFINITION
> DTMF & DIALING
Declare 2833 in SDP = Yes
1st tx DTMF Opt = RFC2833
Max Digits = 11
Interdigit =1 (could set longer if customer dials slowly)
12. Select PROTOCOL CONFIGURATION > PROXY, REGISTRATION
IP GROUPS > PROXIES & REGISTRATION
Use default proxy group = yes
Redundancy mode = Homing
13. Select PROTOCOL CONFIGURATION > CODERS AND PROFILE
DEFINITIONS > CODERS
Set the Media Setting to G711u-law and G729.
Set P-time be set to 20.